Fitting HoseGrip LeakStop
1
Step 1 – Cut & Clean
To start, cut a MINIMUM OF AN INCH off of your hose and remove any crushed or split sections so the edge is clean, straight and round.
Fit HoseGrip in minutes for a leak-free connection.
2
Step 2 – Push Firmly
Push the hose through the two parts of the HoseGrip fitting. Then, with the hose freshly cut to ensure a clean end, push it into the rear of your existing fitting. Make sure the hose has gripped the centre pipe securely and is fully inserted. The hose should be pushed all the way home, which is approximately 20mm.
3
Step 3 – Twist Lock
Turn hand-tight the first locking collar onto the back of your Hozelock connector, then follow with the larger shroud and screw this directly onto the first locking collar.
_mp4.png)
4
You’ll Need:
- HoseGrip LeakStop fitting
- Garden hose
- Sharp knife or hose cutter
- Water source (tap or outdoor faucet)
Avoid These Common Mistakes:
-
Using a hose end that is split or badly worn
-
Not pushing the hose fully into the fitting
-
Leaving the collar loose instead of hand-tight
-
Step 4 – Turn On & Check
Turn on the water and check for leaks. Enjoy a consistent spray and a secure connection that won’t pop off.
Watch how below
1
2
3
Engineered in Devon, UK · Patent-pending leak-lock technology · Built to outlast standard click-lock fittings